Quality Washington GA septic system installers do a number of legwork, long before a unit gets installed into the ground. A brand new unit will last years, and possibly even generations, if it’s set up properly, but it can fall short instantaneously if it’s not. Additionally, all Washington GA septic system installers must secure a permit for them to perform the install, and may need to work with city or county officials to show that a number of tests were done in order to continue. These three tests are essential primary steps that should always be taken before any task or designs are done, and it may also be helpful to do them before you buy a property, so you can be assured that a tank and leach field will be allowed.
1. Pit
The pit test is quite direct. In the course of this test, a hole is excavated and the soil is analyzed to establish its structure. A conventional leach field is reliant on the soil’s composition to drain effectively. If there is a considerable amount of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a bunch of clay or rock, it won’t drain well, consequently a standard leach field will not be an option. If the location you’ve selected does not successfully pass the pit test, you may be able to pick another site on your property or use an alternate kind of drain field, like a mound system.
2. Perc
The perc, or percolation test, calls for digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is typically left drenched for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are a variety of things an inspector will check into visually. Most units are gravity-fed, so they don’t depend on electricity or pumps to transfer effluent from the tank to the leach field. Because of this, the incline of the ground is important. An inspector will also try to find slopes that can feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Hire Quality Washington GA Septic System Installers Today
Choosing the right design, kind of system, and evaluating the land correctly, are all important procedures in making sure an install goes off without a hitch. Most importantly, these steps guarantee that the install is done correctly, so that a system provides decades of use without problems. If you’re prepping for an install, call Septic Tank Pros Athens GA. Our partner technicians are knowledgeable and committed to quality, so you can be sure the job is done right. Call (706) 608-8250 now.