Quality Rayle GA septic system installers do a number of legwork, long before a unit gets installed into the ground. A brand new unit will last years, and possibly even generations, if it’s installed properly, but it can fail right away if it’s not. On top of that, all Rayle GA septic system installers must obtain a permit in order to execute the install, and may ought to coordinate with city or county officials to show that specific tests were performed in order to progress. These three evaluations are necessary primary steps that should always be taken before any job or designs are done, and it may also be beneficial to accomplish them before you buy a property, so you can be assured that a tank and leach field will be permitted.
1. Pit
The pit test is relatively straightforward. During the course of this test, a hole is dug and the soil is inspected to determine its composition. A typical leach field is dependent on the soil’s composition to drain effectively. If there is a bunch of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a considerable amount of clay or rock, it won’t drain well, consequently a conventional leach field will not be an option. If the site you’ve selected does not pass the pit test, you may be able to select another site on your property or use an alternate type of drain field, like a mound system.
2. Perc
The perc, or percolation test, requires excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is commonly left saturated for about two hours, and refilled as needed. Then, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are a variety of things an inspector will check into visually. Many units are gravity-fed, so they don’t depend on electricity or pumps to shift effluent from the tank to the leach field. Because of this, the incline of the ground is very important. An inspector will also search for inclines that could feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Work with Quality Rayle GA Septic System Installers Now
Picking the right configuration, type of system, and evaluating the land effectively, are all essential steps in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done properly, so that a system provides years of use without problems. If you’re prepping for an install, contact Septic Tank Pros Athens GA. Our partner professionals are knowledgeable and dedicated to quality, so you could be sure the job is done right. Call (706) 608-8250 now.