Quality Jefferson GA septic system installers do a number of legwork, long before a unit gets installed into the ground. A new unit will last decades, and possibly even generations, if it’s set up correctly, but it can fail right away if it’s not. On top of that, all Jefferson GA septic system installers must obtain a permit in order to do the install, and may ought to coordinate with city or county officials to show that specific tests were performed in order to continue. These three tests are necessary first steps that should always be taken before any work or designs are done, and it may also be advantageous to do them before you purchase a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is pretty uncomplicated. In the course of this test, a hole is dug down and the soil is examined to establish its composition. A conventional leach field is dependent on the soil’s structure to drain efficiently. If there is a lot of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a lot of clay or rock, it won’t drain well, and so a traditional leach field will not be an alternative. If the site you’ve picked does not successfully pass the pit test, you may be able to choose another site on your house or use an alternate kind of drain field, like a mound system.
2. Perc
The perc, or percolation test, calls for excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is commonly left soaked for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are many things an inspector will check into visually. Many units are gravity-fed, so they don’t rely on electricity or pumps to move effluent from the tank to the leach field. Because of this, the incline of the ground is essential. An inspector will also look for slopes that can feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Work with Quality Jefferson GA Septic System Installers Now
Choosing the right configuration, kind of system, and assessing the land correctly, are all essential steps in making sure an install goes off without a hitch. Most importantly, these steps ensure that the install is done properly, so that a system provides decades of use without issue. If you’re prepping for an install, call Septic Tank Pros Athens GA. Our partner service technicians are experienced and devoted to quality, so you can be sure the job is done right. Call (706) 608-8250 today.