Quality Danielsville GA septic system installers do a great deal of examination, long before a unit gets put into the ground. A new unit will last decades, and possibly even generations, if it’s set up properly, but it can break down right away if it’s not. Furthermore, all Danielsville GA septic system installers must secure a permit in order to perform the install, and may will have to work with city or county officials to show that specific tests were performed in order to proceed. These three assessments are important first steps that should always be taken before any work or designs are done, and it may also be helpful to perform them before you purchase a property, so you could be assured that a tank and leach field will be permitted.
1. Pit
The pit test is quite straightforward. During the course of this test, a hole is excavated and the soil is analyzed to figure out its composition. A standard leach field is reliant on the soil’s structure to drain efficiently. If there is a considerable amount of gravel or sand, your leach field should be capable to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a considerable amount of clay or rock, it won’t sink well, consequently a conventional leach field will not be an alternative. If the site you’ve picked does not pass the pit test, you may be able to pick another site on your home or use an alternate type of drain field, like a mound system.
2. Perc
The perc, or percolation test, involves excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is generally left saturated for about two hours, and topped off as needed. After this, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are a variety of things an inspector will check into visually. Most units are gravity-fed, so they don’t rely upon electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the slope of the ground is vital. An inspector will also search for slopes that can feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Danielsville GA Septic System Installers Now
Selecting the right layout, style of system, and assessing the land effectively, are all integral procedures in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done correctly, so that a system provides decades of use without problems. If you’re preparing for an install, contact Septic Tank Pros Athens GA. Our partner professionals are knowledgeable and dedicated to quality, so you could be sure the job is done right. Call (706) 608-8250 today.