Quality Bishop GA septic system installers do a lot of legwork, long before a unit gets placed into the ground. A brand new unit will last decades, and possibly even generations, if it’s installed correctly, but it can malfunction instantaneously if it’s not. On top of that, all Bishop GA septic system installers must obtain a permit in order to do the install, and may need to coordinate with city or county officials to show that particular tests were performed in order to proceed. These three tests are vital primary steps that should always be taken before any work or designs are done, and it may also be advantageous to do them before you purchase a property, so you could be assured that a tank and leach field will be permitted.
1. Pit
The pit test is fairly uncomplicated. During this test, a hole is excavated and the soil is analyzed to figure out its structure. A standard leach field is dependent on the soil’s composition to drain effectively. If there is a bunch of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a bunch of clay or rock, it won’t sink well, consequently a traditional leach field will not be an option. If the site you’ve chosen does not successfully pass the pit test, you may be able to choose another site on your property or use an alternate kind of drain field, like a mound system.
2. Perc
The perc, or percolation test, involves excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is commonly left saturated for about two hours, and topped off as needed. After this, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are a variety of things an inspector will investigate visually. The majority of units are gravity-fed, so they don’t rely upon electricity or pumps to move effluent from the tank to the leach field. Because of this, the slope of the ground is vital. An inspector will also search for slopes that could feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Hire Quality Bishop GA Septic System Installers Today
Choosing the right design, style of system, and evaluating the land properly, are all important procedures in making sure an install goes off without a hitch. Most significantly, these steps guarantee that the install is done correctly, so that a system provides many years of use without problems. If you’re prepping for an install, contact Septic Tank Pros Athens GA. Our partner technicians are experienced and committed to quality, so you could be sure the job is done right. Call (706) 608-8250 now.