Quality White Plains GA septic system installers do a number of legwork, long before a unit gets placed into the ground. A brand new unit will last decades, and possibly even generations, if it’s set up the right way, but it can fall short instantaneously if it’s not. On top of that, all White Plains GA septic system installers must secure a permit for them to carry out the install, and may will have to collaborate with city or county officials to show that a number of tests were performed in order to move on. These three assessments are important initial steps that should always be taken before any job or designs are done, and it may also be advantageous to accomplish them before you acquire a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is very uncomplicated. During this test, a hole is dug down and the soil is examined to figure out its structure. A typical leach field is dependent on the soil’s composition to drain successfully. If there is a lot of gravel or sand, your leach field should be capable to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a lot of clay or rock, it won’t drain well, and so a conventional leach field will not be an alternative. If the site you’ve selected does not successfully pass the pit test, you may be able to choose another site on your home or use an alternate type of drain field, such as a mound system.
2. Perc
The perc, or percolation test, requires digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is typically left drenched for about two hours, and refilled as needed. Then, the hole is filled with 6 inches of water and observed for drainage.
3. Visual
There are several things an inspector will look into visually. Most units are gravity-fed, so they don’t rely on electricity or pumps to move effluent from the tank to the leach field. Because of this, the incline of the ground is very important. An inspector will also look for inclines that can feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality White Plains GA Septic System Installers Today
Choosing the right configuration, type of system, and assessing the land correctly, are all important steps in making sure an install goes off without a hitch. Most importantly, these steps ensure that the install is done properly, so that a system provides years of use without problems. If you’re preparing for an install, contact Septic Tank Pros Athens GA. Our partner service technicians are knowledgeable and dedicated to quality, so you could be sure the job is done right. Call (706) 608-8250 today.