Quality Athens-Clarke County GA septic system installers do a lot of legwork, long before a unit gets put into the ground. A new unit will last decades, and possibly even generations, if it’s placed correctly, but it can break down right away if it’s not. Additionally, all Athens-Clarke County GA septic system installers must acquire a permit for them to perform the install, and may need to partner with city or county officials to show that certain tests were run in order to proceed. These three tests are vital first steps that should always be taken before any work or designs are done, and it may also be beneficial to accomplish them before you buy a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is fairly uncomplicated. During this test, a hole is excavated and the soil is inspected to figure out its composition. A typical leach field is dependent on the soil’s composition to drain effectively. If there is a lot of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a considerable amount of clay or rock, it won’t sink well, therefore a traditional leach field will not be an option. If the location you’ve selected does not successfully pass the pit test, you may be able to select another site on your house or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, involves excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is commonly left soaked for about two hours, and topped off as needed. Then, the hole is filled with 6 inches of water and monitored for drainage.
3. Visual
There are numerous things an inspector will check visually. A lot of units are gravity-fed, so they don’t rely on electricity or pumps to transfer effluent from the tank to the leach field. As a result of this, the slope of the ground is vital. An inspector will also look for inclines that could possibly feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Choose Quality Athens-Clarke County GA Septic System Installers Now
Choosing the right design, type of system, and evaluating the land correctly, are all fundamental procedures in making sure an install goes off without a hitch. Most significantly, these steps guarantee that the install is done correctly, so that a system provides many years of use without problems. If you’re preparing for an install, contact Septic Tank Pros Athens GA. Our partner specialists are knowledgeable and committed to quality, so you could be sure the job is done right. Call (706) 608-8250 right now.